Job Description

Hygiene Technician II

SCOPE OF WORK

Scope of WORK shall include but is not limited to the following:

1. Inspect, test and assess the performance of the existing engineering control equipment and its associated components.
2. Evaluate and recommend where necessary, remedial or improvement measures should be made on any malfunctioning areas of the engineering control equipment that require modifications.
3. Establish existing performance & operating conditions of the engineering control equipment;
4. Conduct smoke test and measurement of capture/face velocity, static pressure, velocity pressure, transport velocity and determine either face/capture and transport velocities are within the operating range as imposed by ACGIH for engineering control equipment;
5. Determine the pressure drop across air cleaners and to detect any clogging or leaking on the air cleaner device if any;
6. Conduct measurement for fan static pressure, fan total pressure, brake horsepower, RPM, volumetric flow rate and efficiency of the fan;
7. Inspect condition of air cleaner device and measurement of pressure drop (if any);
8. Verify compliance with original design data or comparing it with previous measurements or required face/capture or duct velocities as recommended under industrial ventilation: A Manual of Recommended Practice 30th Edition by American Conference of Governmental Industrial Hygienists (ACGIH);
9. Demonstrate compliance with Occupational Safety & Health (OSH) Acts and Regulations in particular USECHH Regulations 2000;

Competency

• Possess “Orang Yang Kompeten (OYK)” card issued by DOSH
• Possess a valid DOSH Certificate of Competency in Inspection, Examination, and Testing of LEV System
• At least two (2) years’ experience in performing local exhaust ventilation assessment in oil and gas industry

Qualification

• Possess at least a Diploma in Science, Diploma in Engineering, or Diploma in Occupational Safety and Health (OSH) recognized by MQA and attend the course and pass the HT2 examination at a training centre registered with the Director General, or
• Possess at least a Diploma in Industrial Hygiene recognized by MQA; and pass the HT2 examination at a training centre registered with the Director General, or
• Be recognized as an Industrial Hygienist or Occupational Hygienist by an organization recognized by JKKP and pass the HT2 examination at a training centre registered with Director General